Quick Jump Menu
Info Ask a Question
Advanced Search Search the Knowledgebase
Find frequently asked questions, tips & tricks, and how to's. If you still require assistance, do not hesitate to ring Aaron's PT Support, where technicians are ready to help! 1 (855) 202-3949
Categories
There are no subcategories in this category.
1 CLEANING THE MAYTAG WASHER Featured

NOW ON THE MAYTAG THAT HAVE THE LOWER ACCESS PLATE YOU WILL NEED TO REMOVE THREE ¼” SCREWS AT THE BOTTOM TO REMOVE THIS PLATE •NOW YOU CAN SEE THE TRAP •AGAIN ITS RIGHTY TIGHTY/LEFTY LOOSY •REMOVE THE TRAP CLEAN ANY DEBRIS FROM THE TRAP ALSO WITH…

2 Maytag Centennial Washer Balance Problems Featured

Centennial Washer Balance Problems: The Maytag Centennial washer’s tub is suspended on 4 suspension rods located on the outer corners of the washer’s tub. The spring portion of these tub suspension rods have been known to become soft and allow the tub…

3 Maytag Centennial Washer Faults & Errors Featured

Maytag Centennial Washer Faults & Errors Error F0 = no Centennial fault has been recorded. Error F0E2 = Centennial washer drain problem, to much soap suds. Error F0E4 = water during washer’s rinse cycle is more that 105º. Error F0E5 = Centennial washer…

4 Maytag Stackables Error Codes Featured

MAYTAG Stackable A/W and Dryer Fault Codes Failure Code Condition Check/Repair "L" persists in washer display Lid lock failure Replace switch, linkage, lock solenoid or control board. 1E persists in washer display Lid lock failure Replace lid lock switch…

5 Maytag Washer Beep Featured

End Beep: Use this to turn the signal indicating the end of the wash cycle to low, medium, high or off. NOTE: You may also turn off the tones that sound when a feature, setting or option is touched. Touch and hold End Beep for about three seconds to turn…

6 Maytag Washer Diagnostic Mode and Tests Featured

Maytag Centennial Washer Diagnostic Mode & Tests The washer’s diagnostic mode can be used to troubleshoot washer problems by viewing logged washer errors, performing an automatic diagnostic cycle, or manually turning on and off different washer parts…

7 Maytag Washer Drive Pulley Problems Featured

Washer Drive Pulley Problems: In most cases the washer will basically work normally except for a horrible noise when the washer is washing or spinning. The washer’s drive pulley can become loose and slip down causing a loud, fast ticking sound whenever…

8 Maytag Washer lid lock Problems Featured

Washer lid lock Problems: The lid latch has been a sore spot on this washer type. Most often washer lid latch problems result in the washer not starting or a fault code such as F5E1, F5E2, or F5E3. The washer’s lid strike attached to the lid can also swell…

9 Re-calibration for Washers Featured

Re-calibration Steps: Start With the cycle selector knob in the normal position. Rotate the cycle selector knob: One click to the left Three clicks to the right One click to the left One click to the right DO THIS SLOWLY (Count a full second between clicks)…

10 Maytag Master Reset

Master Reset, carefully unplug the washing machine from the power outlet and leave it unplugged for one minute. After one minute is up, plug the washer cord back into the wall. Next, open and close the door of the washing machine 6 times within 12 seconds…

1 2 Next