Quick Jump Menu
Info Ask a Question
Advanced Search Search the Knowledgebase
Find frequently asked questions, tips & tricks, and how to's. If you still require assistance, do not hesitate to ring Aaron's PT Support, where technicians are ready to help! 1 (855) 202-3949
 Featured
Service mode on a GE Front Load Washer
Author: Aimee Summers Reference Number: AA-00240 Views: 2089 Created: 2016-02-09 22:16 Last Updated: 2018-08-09 21:40 0 Rating/ Voters

Entering And Exiting The Service Mode On A GE Front Load Washer 


Follow these steps to enter the service mode on a GE front load washer. 

1. Close the door. 

2. Clear current cycles by pressing the power button. Make sure the screen is blank before attempting to enter the service mode. 

3. Disconnect power to washer for at least 30 seconds. 

4. Reconnect the power and within 30 seconds of reconnecting power complete the next step. 

5. Press signal -delay start -signal - delay start. 

If you successfully enter the washer into the service mode, t01 will be displayed and the door will lock.



Note: Entering the service mode is a little different on models GFWN1000, GFAN1000,GFWN1100, and GFAN1100. To enter the service mode on these models press signal, extra rinse, signal and extra rinse. Press the same button sequence to exit the service mode. 

Never disconnect the power to the washer while it is in the service mode. Doing so may result in a damaged control board. 

To exit the service mode press signal -delay start -signal - delay start.

Rss Comments
  • There are no comments for this article.
Info Add Comment
Nickname: Your Email: Subject: Comment:
Enter the code below: